Installing memory in pc

In addition, which slots you go with will also depend on how many RAM sticks you have. If you just have one stick, you don't have to fill Slot 2. In the case of a motherboard with four RAM slots, it's probable you'll want to install your first RAM stick into the slot labeled 1.

A second stick should go into Slot 2, which isn't next to Slot 1. If you have a third stick, it would go into Slot 3, which will actually be between Slot 1 and Slot 2.

Finally, a fourth stick would go into Slot 4. You must always consult your motherboard manual. It all depends on your motherboard.

Don't worry, though. Step 8 - Install Memory. Memory banks. Step 9 - Close the Computer Case. Step 10 - Plug the Power Cable in. Your Memory is now Installed! Helpful Hints and Installation Troubleshooting Tips. If your system does not boot up, check the following items: If you receive an error message or hear a series of beeps, your system might not be recognizing the new memory modules.

Remove and reinstall the modules. Push down hard on the modules until the clips fold back up. If your system won't boot, check all the connections inside your computer. It is easy to bump a cable and pull it out of its connector, which will disable devices such as your hard drive or CD-ROM. When restarting your system, you might get a message prompting you to update the configuration settings.

Refer to your owner's manual for information. If you are still unsure, please call Crucial Technical Support for assistance. If you get a memory mismatch message, follow the prompts to enter the Setup menu, and then select Save and Exit. This is not an error—some systems must do this to update the system settings. If the groove on the memory module and the ridge in the computer do not match up, do not force the module into the slot. You might have the wrong type of memory.

Your system recognizes only half of the new module's memory. It should match the amount you installed. Step 5. Check the layout of RAM slots. Some motherboards have 4 slots for RAM, but they are not installed directly next to each other.

Step 6. Install RAM. Hold the modules along the edges and push each module directly into the slot, ensuring that the notches are at the bottom line up. Step 7. Close up the computer case. With the RAM installed, you can close the case and screw the case panel back into place.

Step 8. Plug in the power cable and try booting your computer. Now, you can check if your computer can boot smoothly. I believe you already have an overall understanding of the guide.

Download Partition Wizard.